Skip to main content
search
Press Releases

RJ Watson Bearing Replacement on Zilwaukee Bridge featured in Aspire Magazine

By April 18, 2014No Comments
RJ Watson

AspireBook_Spring 2014_Zilwaukee

The Zilwaukee Bridge, a 1.5-mile-long twin concrete segmental structure, carries I-75 traffic over the Saginaw River. All Photos: Michigan Department of Transportation.

profile

ZILWAUKEE BRIDGE / ZILWAUKEE, MICHIGAN
BRIDGE REPLACEMENT CONSULTANT: T.Y. Lin International, San Francisco, Calif.
QUALITY ASSURANCE ENGINEER: Janssen and Spaans Engineer Inc., Chicago, Ill.
CONSTRUCTION ENGINEER: Corven Engineering Inc., Tallahassee, Fla.
PRIME CONTRACTOR: PCL Construction, Tampa, Fla.
POST-TENSIONING CONTRACTORS: PCL Construction, Tampa, Fla., and Walter Toebe Construction, Wixom, Mich.

12 | ASPIRE, Spring 2014

Bearing Replacement

The challenges associated with the bearing replacement were clear. Loads approaching 17 million pounds would have to be jacked from piers with heights up to 130 ft. Then, new, higher capacity bearings would have to be installed into the existing openings with little to no allowable modifications to the structure.

Loads approaching 17 million pounds would have to be jacked from piers with heights up to 130 ft.

The old expansion joint bearings rested on reinforced, cantilevered concrete corbels containing the anchorages for the post-tensioning. Therefore, any modifications to the concrete corbel to gain additional space was limited to the 2 in. of concrete cover above the reinforcing steel. The existing opening housing the expansion joint bearings provided approximately 4 in. of space from corbel to top plate. The top plates were salvaged because they were cast into the upper segment and were in sound condition. This lack of space also meant a higher-capacity and taller pot- style bearing would not be able to be used.

The pier bearings rested directly on top of each pier with a cast-in- place concrete plinth between the top of bearing and bottom of the superstructure. Plinth modifications were made to accommodate various bearing depths. Jacking stresses and load path redistribution were addressed by application of additional external post-tensioning forces via post-tensioning bars and walers to the elements affected. Some of the affected elements required an additional 2.5 million pounds of compression to prevent excess principal tensile stresses during jacking.

read the rest of the article here

Related Posts

Press Releases

Structural Technologies Announces Strategic Partnership with RJ Watson, Inc.

For the Transportation Market Structural Technologies, a Structural Group Company, has formed a strategic partnership…
RJ Watson
RJ WatsonJanuary 9, 2018
Disktron Bearings | RJ Watson Press Releases

Portsmouth Bypass Disktron Installation

Ohio DOT's First P3 Project Uses Disktron Bearings   The largest project in the history…
RJ Watson
RJ WatsonOctober 19, 2017